Monday, May 30, 2016

Clean and Press (Barbell)

Target Muscles: Anterior and medial deltoids, Upper Pectoralis major, Triceps, Shoulder girdle muscles (Trapezius, Supraspinatus)
Starting Position:
1. Assume a shoulder-width stance, with knees inside the arms.
2. While keeping the back flat, bend at the knees and hips so that you can grab the bar with the arms fully extended.
3. Using a pronated grip that is slightly wider than shoulder width grasp the barbell with your elbows out to sides.
4. Keeping the bar close to the shins, position the shoulders over or slightly ahead of the bar.
5. Establish a flat back posture.
The Movement:
1. Begin to pull the bar by extending the knees, while moving your hips forward.
2. Raise the shoulders at the same rate while keeping the angle of the back constant and continue to lift the bar straight up while keeping it close to your body.
3. As the bar passes the knee, extend at the ankles, knees, and hips forcefully, similar to a jumping motion.
4. Continue to guide the bar with your hands, shrugging your shoulders and using the momentum from your movement to pull the bar as high as possible.
5. At maximum elevation, your feet should clear the floor and you should start to pull yourself under the bar.
6. Rotate your elbows around and under the bar and rack the bar across the front of the shoulders while keeping the torso erect and flexing the hips and knees to absorb the weight of the bar.
7. Stand to full height, holding the bar in the clean position.
8. Without moving your feet, press the bar overhead as you exhale.
9. Lower the bar under control.
1. The bar should travel close to your body, and you should keep your elbows out.
2. You should descend into a squatting position as you pull yourself under the bar.

3. The mechanics of this could change slightly, depending on the weight used.