Pulley position: Low pulley.
• Remove the back support and place the seat in free sliding position.
• Use the bar harness to adjust strap length allowing tension at the appropriate depth. This will require experimentation. Increase depth slowly according to your ability, knee conditions, etc. Most orthopedists recommend that healthy knees not go any lower than a 90 degree angle (between the thigh and calf) when using extra resistance. Many people go lower for their goals, but this dramatically increases the risk to the knee cartilage and increases the probability of degenerative/arthritic changes.
• Sit on the seat facing the Power Rods® and position the bar on the traps (across the shoulders, not on the neck). Maintain a grip on each side of the bar.
• Flatten your back, keep your chest up and position your feet in line with the cable/pulley.
• Place your feet wider than hip width and point your toes outward slightly. Direct the thighs to the same outward angle as the feet.
• While keeping your back straight, tighten your abdominals and move to a standing position.
• Keep the pressure through the middle of the arches/feet, not through the toes or heels.
• Using control, slowly squat down by sticking the hips out as the knees start to bend. Keep the chest up and back flat as the hips continue to move backward.
• Lower to approximately 90 degrees at the knees (unless otherwise determined).
• Do not return to the seat until the end of the last repetition.
• Keep knees pointed the same direction as the toes.
• Keep the head/neck in line with the trunk.
• Pay close attention to all alignment and stabilization issues on every part of each and every repetition!
• Never attempt to exercise with more resistance than you are physically able to handle. And be sure to properly place the bar in a secure location on your shoulders.